cs en ru


The price is dependent on the length of skis and type of bindings.
on the edge
  • specifications
  • construction
  • video
  • inquiry

The LP 76 are women’s downhill skis which, thanks to a width of 76 mm under the boot, will ride you through almost any terrain with stability and without hesitation. You will have fun on a hard groomed piste in the morning as well as on a softer and chopped up snow in the afternoon. The skis are more suitable for short and medium turns and they will please a wide range of women skiers, even though they are mainly targeted at the sportier ones.

Just like all the skis of the LP category, this high-performance, sporty, women’s ski has only one Titanal sheet and is therefore more easily manoeuvrable, yet sufficiently solid and reliable even at medium speeds. The LP 76 are simply obedient, easy to manoeuvre and even minimum effort will turn your ride into a perfect skiing experience.

How they ride:
“The LP 76 are one of my most favourite skis. Maybe also because I spent most of the winter in the Czech mountains, where the ski slope is usually slushy as early as around 10 o’clock. Even on a relatively chopped ski slope I can make each turn as I want and as I like, because thanks to a waste width of 76 mm I don’t brush with my boot against uneven spots on the ski slope. However, I also like to take these skis to an icy slope in the morning, because with a ski so wide I have a feeling of great stability and certainty. I like to push the skis to the limit and they will always perfectly support me.” (Radka Luštincová (1990), LP 76 162 cm)

87° from side
0,5° from the bottom

Mounting point for optional mounting of the binding
(measured from the heel):

141 cm – 59,5 cm  
148 cm – 62,5 cm
155 cm – 65,5 cm
162 cm – 69,0 cm


To produce these skis is used quality structured polyamide topsheet from the largest European supplier ISOSPORT.

Lamination layer

In these skis are used two biaxial and one triaxial prepreg carrier layer. A prepreg is a cloth that is already completely saturated by the manufacturer. The material is more expensive, but this is the way to eliminate errors in the saturation of the fabric.


Titanal is high quality carrier layer, that is used in the manufacture of skis. This layer significantly improves longitudinal and torsional rigidity. In these skis is used one sheet of titanal.


We use a woodcore - unidirectional spruce plywood.


On the sidewall, we use ABS material with guaranteed quality from Europe's largest manufacturer ISOSPORT.


This is not the damping while driving but damping the differences in expansion of the material, it ensure that material hold together. As a damping, we use anti-vibration rubber tape with a thickness of 0.2 mm.


On these skis we use quality steel edges, about hardness 48 ° HRC.


In these skis is used a quality sintered racing base from the largest European manufacturer ISOSPORT.

Celá konstrukce
about our company  
Galus Industries Ltd. is a czech manufacturer of skis, snowboards and other sports equipment. Since 2000, our company began to produce a small quantity for the Czech Market of high performance racing skis under the brand LUSTi. The intention has always been to offer the highest quality at the best price. In the company is also the development of summer products such as longboards, wakeboards and kiteboards.